Voyetra's Sequencer Plus modifies which files are installed based on the settings of the installer. 
Because of this, the program must be installed in DOSBox. However, the installer of Sequencer Plus 
expects to be run from a floppy disk. These instructions will take you through the steps necessary 
to install the program.

These instructions assume you have a folder on your computer where you run your DOS games. I will 
use the folder "C:\DOSGames". Yours is probably different, so substitute the path where needed.

1.) Extract the zip file onto your hard drive and store in the folder: C:\DOSGames\SPLUSPRO.
2.) Open DOSBox.
3.) Mount your DOS folder as the C drive.

         mount c "C:\DOSGames"
		 
	You will see:
	     
		 Drive C is mounted as local directory C:\DOSGAMES\

4.) Mount the SPLUSPRO folder as a labeled floppy disk with the following command:

         mount a "C:\DOSGames\SPLUSPRO" -label "SPPRO DISK" -t floppy
  
    You will see:
  
         Drive A is mounted as local directory C:\DOSGAMES\SPLUSPRO\
  
5.) Change to our newly mounted floppy disk drive with the following command:

         a:
 
6.) Now on the floppy disk, install the program to your hard drive with the following command:

         install c:
		 
7.) If each step was followed correctly, the Voyetra Sequencer Plus installer should run.
    Sequencer Plus will be installed to the DOSBox folder "C:\VOYETRA", or on your actual 
	computer, as "C:\DOSGames\VOYETRA".

8.) To launch Sequencer Plus, change directory to the installed folder:

         c:
		 cd voyetra
		 
    Then run the program by typing:
	
	     sp